To the Owner/Operator: Do not use or operate the machine until the manual has been read and understood. If you require additional information, contact your Dealer or EZ-Spot-UR, Inc.
Operation and Maintenance Manuals are written to give the owner/operator instructions on the safe operation and maintenance of the product. For your safety and the safety of others, you must not operate, service, inspect or otherwise handle this equipment before you have reviewed and understood the Operation and Maintenance Manual(s) pertaining to the EZ-Spot-UR and the prime mover (skid steer loader) manufacturer.
Throughout the manual reference may be made to the left hand (LH) or right hand (RH) side. These terms are used as viewed from the operator's seat facing front. The left hand and right hand side will be the same as your left hand and right hand.
In order to get the optimum performance and efficiency that has been designed into the EZ-Spot-UR, read this manual thoroughly before setting-up, operating, or performing maintenance procedures on the machine.
It is the responsibility of the user to read the operator’s manual and comply with the safety instructions, operation instructions, and maintenance guidelines set forth in the manual.
The user is responsible for inspecting the machine daily and for having parts repaired or replaced when continued use of the machine causes damage, excessive wear to other parts, or makes the machine unsafe for continued operation.
The signal words CAUTION, WARNING or DANGER are used to indicate degree of hazards and to warn against unsafe practices that may cause personal injury and are used with appropriate safety instructions. These signal words are not to be ignored; your safety is involved.
The word NOTE is used to convey information that is out of context with the manual text: special information such as specifications, techniques, reference information and other information of a supplementary nature.
The word IMPORTANT, is used in the text when immediate damage will occur to the machine due to improper technique or operation. IMPORTANT will apply to the same information specified by NOTE, only of an immediate and urgent nature.
EZ-Spot-UR, Inc. cannot anticipate every possible circumstance that might involve potential hazards. The safety messages found in the manual and on the machine are therefore not all inclusive. If an operating procedure, tool device, maintenance or work method not specifically recommended is used, you must satisfy yourself that it is safe for you and others. You must also ensure that the machine will not be damaged or made unsafe by the procedures you choose.
SAFETY IS THE OPERATOR'S RESPONSIBILITY
Always read and understand the Operation and Maintenance Manual for this attachment. These attachments are designed to give maximum safety; but no machine design can prevent operator error or carelessness.
Always read, understand, and follow the loader manufacturer’s Operation and Maintenance Manual for all the loader functions and safety information.
Always read and follow the loader manufacturer’s Operation and Maintenance Manual instructions for the correct procedure for raising and lowering the operations cab and/or the loader lift arms. Always install an approved lift arm support device when the lift arms are in the raised position for service or maintenance.
Do not exceed the loader manufacturer’s rated operating capacity (ROC) with the weight of the object plus attachment weight.
An open cab is not recommended by the manufacturer. If an operator chooses to use a machine with an open cab, they do so at their own risk!
Always wear relevant safety apparel. If using a skid steer with an open cab, always wear safety glasses and protective head gear.
Skid steer must be equipped with an operator front protective door. Serious injury or death can result from falling objects hitting an unprotected operator.
Check the rules and regulations at your location. The rules may include an employer’s work safety requirements. Regulations may apply to local driving requirements or use of a SIow Moving Vehicle (SMV) emblem. Regulations may identify a hazard such as a utility line.
Know the location of any underground or overhead lines. Call local utilities for locating underground lines or the TOLL FREE phone number listed below.
Check that the attachment mount levers are in the locked position and the wedges are fully engaged into the holes of the attachment.
When learning to operate the attachment, do it at a slow rate in an area clear of bystanders.
DO NOT permit personnel to be in the work area when operating the loader and attachment.
Before leaving the loader operator’s seat, always lower the lift arms fully, engage the brake and stop the engine.
DO NOT make any adjustments or repairs on the loader or the attachment while the loader engine is running.
Call Before You Dig
1-888-258-0808
When you call, you will be directed to a location in your state/city for information about buried lines (internet, telephone, cable TV, water, sewer, gas, etc.)
EZ-Spot-UR attachments are built with iron-clad reinforcement. For even greater peace of mind, every serial-numbered attachment is backed by a 12-month warranty. See below for specific warranty details.
Warranty Statement
EZ-Spot-UR warrants to its authorized dealer of EZ-Spot-UR Inc., who in turn, warrant to the original owner, that each new EZ-Spot-UR attachment will be free from proven defects in material and workmanship for twelve (12) months after delivery by EZ-Spot-UR or authorized dealer to the original buyer.
During the warranty period, EZ-Spot-UR Inc. or the authorized EZ-Spot-UR dealer shall repair or replace, at EZ-Spot-UR Inc’s. option, without charge for parts and labor, any part of the EZ-Spot-UR product which fails because of defects in material or workmanship. The owner shall provide the authorized dealer or EZ-Spot-UR Inc. with prompt written notice of the defect and allow reasonable time for replacement or repair. EZ-Spot-UR Inc. may, at its option, require failed parts to be returned to the factory. Travel time of mechanics and transportation of the EZ-Spot-UR product to the authorized EZ-Spot-UR dealer or EZ-Spot-UR Inc. for warranty work are the responsibility of the owner. The remedies provided in this warrant are exclusive.
This warranty does not cover replacement of scheduled service items and high wear items. The owner shall rely solely on the warranty, if any, of the respective manufacturers thereof. This warranty does not cover damages resulting from abuse, accidents, alterations, use of the EZ-Spot-UR product as an attachment on any equipment not approved by EZ-Spot-UR Inc., or failure to maintain or use the EZ-Spot-UR product according to the instructions applicable to it.
This warranty is exclusive and in lieu of all other warranties and conditions, except the warranty of title. EZ-Spot-UR Inc. disclaims all other warranties and conditions, express or implied, including any implied warranties and conditions of merchantability or fitness for a particular purpose. In no event shall EZ-Spot-UR Inc. or the authorized EZ-Spot-UR dealer be liable for any special, incidental, indirect or consequential damage, whatsoever, including, but not limited to, loss or interruption of business, lost profits, or loss of attachment use, whether based on contract, warranty, tort, negligence, strict liability, statute or otherwise, even if EZ-Spot-UR Inc. or the authorized EZ-Spot-UR dealers with respect to the product and services furnished hereunder shall not exceed the purchase price of the product upon which such liability is based.
Conditions of Warranty
All EZ-Spot-UR serial numbered attachments are covered with a twelve-month New Equipment Warranty. All non-serial numbered attachments are sold as is and carry no warranty through EZ-Spot-UR Inc. or approved dealers. This coverage applies to proved defects in material and workmanship on all attachment components, except normal wear items. An EZ-Spot-UR attachment is defined as either being manufactured by EZ-Spot-UR Inc. or having been approved by EZ-Spot-UR engineering and sold by EZ-Spot-UR.
Abuse:
Failure resulting from neglect, such as improper operation and lack of required maintenance.
Alterations:
Modification of attachments not having special approval from EZ-Spot-UR Inc. Engineering Department.
Damage:
Failures caused by carelessness or accidents such as improper operation, transportation or storage of the attachment.
Application and/or Environmental Conditions:
Deteriorated or failed components such as: connections, gaskets, hoses, seals and tube lines caused by chemicals, falling objects dirt and sand, excessive heat or moisture. Warranty determination for these types of failures will be made by the EZ-Spot-UR Service Department, after inspection of failed component.
Maintenance:
Component failure caused by not performing scheduled maintenance service, such as: not maintaining adequate fuel levels in hydraulic systems. Not tightening or replacing loose or missing bolts, nuts, fittings, shields and shrouds.
Adjustments:
Such as but not limited to: drive and digging chains, cutting tooth alignment, etc., are considered normal maintenance, and will not be covered under warranty after 30 days of operation.
Normal Wear:
Maintenance items such as: oils and lubricants, chains, pins and bushings are considered to be normal consumable items and are not warrantied. A special consideration will be allowed for fluids lost due to defective parts, such as: broken hydraulic hoses and lines, reservoirs, or tanks if within reason.
Electrical Components
Electrical harnesses, plugs, and other electrical components are considered normal maintenance, and will not be covered under warranty after 30 days.
Unauthorized Repair:
Warrantied components must be replaced with EZ-Spot-UR repair parts. Warranty repair must be done by an authorized EZ-Spot-UR dealer or by EZ-Spot-UR Inc.
Travel Time:
Travel time required for warranty repairs is the responsibility of the owner. Because attachments are easily transportable and owners oftentimes very mobile, it becomes increasingly difficult for a dealer or EZ-Spot-UR to accept the responsibility for the distance between the EZ-Spot-UR location and the dealer service shop. Therefore EZ-Spot-UR does not pay travel time.
Hauling Expense:
EZ-Spot-UR does not pay for hauling the attachment for repair or replacement of warrantied components.
Diagnostic Time:
EZ-Spot-UR does not pay for time required to diagnose a warranty problem. Diagnostic time is affected greatly by the training and expertise of the technician employed to do the job. With proper training of your service personnel diagnostic time should be at a minimum. We are also confident that you will assign your best trained-most proficient technician to handle warranty repairs. Since we at EZ-Spot-UR are not in control of either of these responsibilities we therefore have elected not to pay diagnostic time.
Clean-Up Time:
EZ-Spot-UR does not pay for cleaning the attachment or work area before or after the warranty repair. Clean-Up Time is affected primarily by the application or conditions in which the machine is operated and in most cases could be considered a customer expense. Since clean-up time can be so variable, we do not reimburse for clean-up time and is not part of the suggested repair time.
Shop Supplies:
EZ-Spot-UR does not pay for miscellaneous shop supplies or special tools.
Shortages:
Options ordered and not received must be addressed directly to EZ-Spot-UR, Inc.
Unauthorized Modification Warning:
Any modifications to product without written consent from manufacturer voids any, and all warranty!
WARRANTY POLICY
EZ-Spot-UR, Inc. warrants their products to be free from defects and material and workmanship for a period of One (1) year from the date of delivery. This warranty does not apply to any product which has been subject to a misuse, negligence, accidental damage or if the unit has been modified in any way.
Satisfaction of this warranty, consistent with other provisions herein, will be limited to the replacement, or repair or modification of, or issuance of a credit for the Goods involved, at EZ- Spot-UR, Inc.’s option, only after the return of such Goods with consent in accordance with the Return Policy and with shipping charges prepaid. Any warranty service (consisting of time, travel, and expenses relate to such services) performed other than at EZ-Spot-UR, Inc.’s factory shall be at Customer’s expense.
THIS WARRANTY IS IN LIEU OF ALL OTHER WARRANTIES WHETHER EXPRESSED, IMPLIED OR STATUTORY INCLUDING IMPLIED WARRANTIES OF MERCHANTABILITY OR FITNESS.
General
EZ-Spot-UR, Inc. and Customer agree that the terms and conditions identified in this document shall govern exclusively the sales by EZ-Spot-UR, Inc. Of all Units and Attachments (collectively referred to as "Goods”) within the United States. No addition or modification to any of the terms and conditions as they appear in this document shall be binding upon EZ-Spot-UR, Inc. unless in writing and signed by EZ-Spot-UR, Inc., or its Authorized Agents.
Terms
Terms to Customers with satisfactory credit are net thirty (30) days from date of invoice. A 1-1/2% monthly service charge (18% annually) may be added to accounts not paid within 30 days from date of invoice at the discretion of EZ-Spot-UR, Inc.
Shipment
All prices quoted (including repairs, parts, and goods sold separately) are F.O.B. Manufacturer’s factory.
Title and Responsibility
Title to Goods shall remain with EZ-Spot-UR, Inc. as security only and until full payment, therefore. Risk of loss or damage shall pass to Customer upon shipment from F.O.B. point.
Price Changes
All prices in printed matter as well as written or verbal quotations are subject to change without further notice and must be confirmed when placing an order.
Penalty Clauses
No contracts or quotations showing penalty clause for failure to meet shipment are acceptable to EZ-Spot-UR, Inc.
Product Changes
Changes in design and improvements in manufacture may be made by EZ-Spot-UR, Inc. whenever the company believes the product will be improved. No obligation to incorporate these changes in units manufactured prior to the change will be assumed.
Shipping Weight and Dimensions
Published weights are careful estimates but are not warranted. Dimensions shown in catalog are approximate.
Quotations
All written quotations automatically expire unless accepted within thirty (30) days from the date quoted. Verbal quotations expire the same day they are made.
Taxes
The Customer shall pay all sales, use, excise, or similar taxes to the appropriate agency where and when applicable.
Delay
Manufacturer shall not be liable for damage as a result of any delay due to any cause beyond Manufacturer’s reasonable control including, without limitation, act of God, act of war, riot, delay in transportation or inability to obtain necessary labor, materials, or manufacturing facilities. In the event of any such delay, the date of delivery shall be extended for a period equal to a time lost by reason of delay.
Limitation of Liability
ln no event shall Manufacturer be liable for consequential or incidental damages or any expense incurred by the Customer attributed to any product sold hereunder.
Field Repair Services
All repair orders require a purchase order number from the Customer. Warranty repairs, as determined by Manufacturer, and the cost of estimating a repair are billed at no charge.
EZ-Spot-UR, Inc.
803 25th Street North, Fargo, North Dakota 58102, United States
Copyright © 2024 EZ-Spot-UR, Inc. - All Rights Reserved.
*****EZ-Spot-UR, Inc. is not affiliated with, associated with, sponsored by, or endorsed by any manufacturer of skid steer loaders or machinery shown in these advertising materials.*****
We use cookies to analyze website traffic and optimize your website experience. By accepting our use of cookies, your data will be aggregated with all other user data.